Installing in the Oregon Maple, part 2

We decided to install and leave the highest ‘tendon’ in place even though the exhibition is not due to open to the public until Friday the 29th. It would have been too difficult to get back to the same height again. I had decided on mirroring two metal wires, which ran more or less parallel to each other near the topmost branches of the tree.

IMG-0700lo res

See image of the end points of the chosen pair of cables where they are fixed to the tree.

David positioned us and we began cutting, stretching and cable tying the beginning of the length of fabric between the two wires. We continued cable tying the fabric along the length of the wires until the distance between them became impossible to cover. At this point I needed to ‘carve’ the tendon shape into the fabric attaching it’s end points securely to the wires.

This slideshow requires JavaScript.

Slide show of different of the piece in situ from various positions as we descended from the heights of the top branches of the Oregon Maple to the ground level.

Having finished finessing this tendon we dropped down to the lower levels of the branches to measure up for the final two tendons. Both of these tendons will run more or less parallel to each other with variations on their angles and will be nearly perpendicular to the highest tendon. David and I again moved into position and began to temporarily tie the other two tendons nearer the base of the trunk and cut the fabric length to size. These sections were taken away to allow the artist to further cut into the fabric, shape it, sew the edges and afix the eyelets.

Images of the final two ‘tendons’ and the complete installation in the Oregon Maple will be available to view after the exhibition opens to the public.